A&D AD-8922A Bedienerhandbuch PDF herunterladen (Seite 30)

１１-３ Setting the Upper and Lower Limit Values

 Up to 10 set of upper and lower limit values can be stored.

 Using the stored upper and lower limit values, comparison can be performed easily. To recall the

stored values, press and hold the ON:OFF key and press the MODE key.

１１-３-１ Storing the upper and lower limit values

To store new upper and lower limit values, recall the stored data ("C01" to "C10") and change them.

1. While pressing and holding the ON:OFF key, press the RE-ZERO key to enter the confirmation

mode. The upper limit value data (Comparator number and the upper limit mass (blinking)) of the

comparator number that was selected last.

Displaying example

2. Select the comparator number using the following keys.

RE-ZERO key To increase the comparator number by 1.

MODE key To decrease the comparator number by 1.

Each time the key is pressed, the upper limit value and the lower limit value of the comparator

number selected is displayed alternately. (

C01 HI ⇔ C01 LO ⇔ C02 HI ⇔ C02 LO ⇔…)

3. Press the SAMPLE key to go to the storing mode to change the stored values.

Digital input mode

SAMPLE key To select the digit to change

the value.

RE-ZERO key To change the value of the

digit selected.

MODE key To move the decimal point

position to the right by 1

digit.

ON:OFF key

(press and hold)

MODE key

To switch the polarity.

PRINT key To store the new setting and

return to step 2.

CAL key To cancel the new setting

and return to step 2.

4. Press the CAL key to return to the weighing data

display.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Keine Kommentare

A&D AD-8922A Bedienerhandbuch Seite 30