A&D AD-4408A Bedienerhandbuch PDF herunterladen (Seite 5)

3. Description of Each Part

Fig.1 Interface module part names

NOTE: 1. A TORX

driver (size T9) to fasten the retaining screws is not provided

with the interface module.

2. A connector for the cable side (D-Sub 9-pin male) is not provided with

the interface module.

3.1. Status LEDs

NOTE: The illustration below shows how the interface module is positioned when

installed to the AD-4408A.

Fig.2 Position of status LEDs

Table 1 Status LED (ST)

LED state Description

OFF Not initialized / No power

Green ON Normal

Green, flashing Diagnostic event in progress

Red ON Recoverable error

Table 2 Operation mode LED (OP)

LED state Description

OFF Offline / No power

Green ON Online (Normal)

Green, flashing Online (Clear)

Red, single flash Paremeter setting error

Red, double flash PROFIBUS configuration error

Operation mode LED

Status LED

Locking

catch

Ground

NOTE 2

Communication

connecto

NOTE 1

Retaining

screw

Status LED

Operation mode LED

Locking

catch

1 2 3 4 5 6 7 8 9 10 ... 21 22

Keine Kommentare

A&D AD-4408A Bedienerhandbuch Seite 5