A&D SV-10A Bedienerhandbuch PDF herunterladen (Seite 34)

6-2 Basic Measurement Procedure (For the SV-A series)

1 With the power turned off, press the ON:OFF

key.

When the display is in the standby mode, press

the START key. *1

After about 15 seconds, the measurement

values are displayed.

2 During measurement, press the

HOLD key as necessary, to freeze

the display temporarily.

To release the data hold mode,

press the HOLD or START key

again. *2

3 Press the STOP key to stop

the measurement. The

measurement results freeze

and are displayed.

4 To stop the measurement,

press the STOP key.

To go on to the next

measurement, set the sample

and press the START key.

When the viscosity value is below the measuring range, Sl TOP is displayed.

When the viscosity value exceeds the measuring range, SH TOP is displayed.

If the sensor plates are not in vibrating motion for about 20 seconds, for example, when

the sample coagulates, the measurement will stop automatically.

∗1 When the graphing program RsVisco is used, click the START button on the RsVisco to

start a measurement.

∗2 While the measurement is being performed using the graphing program RsVisco or data

are being output continuously (function setting "prt 2" or SIR command), the data hold

mode using the HOLD key is not available.

Below is an exam

le of the SV-10A at shi

ment.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 101 102

Keine Kommentare

A&D SV-10A Bedienerhandbuch Seite 34