A&D OP-11 Installationshandbuch Seite 37

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 182
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 36
07/2011 2 Operating A&D DataManagement
2.4 Specifying the properties of the control components
© Siemens AG 2011 All Rights Reserved
SIMATIC A&D DataManagement Client - 07/2011
2-37
MPI/OPI
MPI (or OPI) address of the NCU
ADDM subsequently creates a link to the NCU SINUMERIK with the MPI
(OPI) address.
A communication error occurs if the stated address is not present (error
286).
Baud rate
Baud rate for the transfer.
ADDM stores the information in the "MMC.INI" file when loading or backing up.
Notice
It is essential to parameterize the interface on the PG/PC in the Tools Set
PG/PC interface menu before transferring via MPI, OPI and PROFIBUS. This
resetting does not take place automatically.
It is preferable to load and backup the NCU over the MPI interface. If you use the
OPI interface, you must still change to the MPI interface to transfer the entire S7
data.
Caution
Check the MPI address before starting the download. If the MPI address is not
set correctly, the data may be transferred to the wrong hardware.
Note
ADDM backs up all the data stored in the NCU. These are essentially machine
data, setting data, drive machine data, compensation values, cycles, subroutines,
main programs and work piece data. Data which has been swapped out to the
operator panel (MMC) has to be backed up separately.
Note
Create a separate S7 object for an S7 PLC integrated into the SINUMERIK, see
subsection 2.4.4 S7 Component.
Seitenansicht 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 181 182

Kommentare zu diesen Handbüchern

Keine Kommentare